Meshtastic Solar Node – RAK4631 US915 with GPS, Solar Panel, Antenna & Magnetic Mount
$235.00
Skip to product information
Meshtastic Solar Node – RAK4631 US915 with GPS, Solar Panel, Antenna & Magnetic Mount
$235.00
Your note shows on the order next to this item.
A ready-to-deploy Meshtastic solar node with GPS. It's built on the RAKwireless WisBlock RAK4631 with the RAK12501 GNSS module installed, powered by a 6W solar panel and a 3000mAh LiPo battery, and housed in a weather-resistant ASA enclosure with magnetic mounts. Every node is assembled and tested in house in Washington, Illinois before it ships.
Only one available. This is a single finished unit. The node in the photos does not have the GPS module installed yet; the one you receive will.
Key Features
- Fully assembled and tested Meshtastic node (US915)
- RAKwireless WisBlock RAK19007 base + RAK4631 core
- RAK12501 GNSS location tracker module installed
- Solar powered with an internal 3000mAh LiPo battery
- Outdoor 915 MHz antenna with a sealed N-type connection
- Solar panel USB cable sealed with marine-grade silicone
- Durable ASA housing with a TPU gasket
- Rubber-coated neodymium magnets (30 lb hold) for vehicle and field mounting
What's Included
- Assembled Meshtastic solar node
- Solar panel
- Outdoor 915 MHz antenna
- Magnetic mounting system
- Internal battery (disconnected for shipping)
Parts in This Build
- Outdoor 915 MHz antenna, similar to the Alpha 915 (the Alpha 915 shown in the photos is not included)
- Superbat N-type female pigtail cable
- FlexSolar 5V 6W monocrystalline USB solar panel
- RAKwireless WisBlock Meshtastic US915 base RAK19007 + core RAK4631
- RAK12501 GNSS location tracker module
- DIYMAG rubber-coated neodymium mounting magnets
- Marine-grade adhesive heat shrink on the antenna connection
- 3.7V 3000mAh LiPo battery
Size
About 200 mm L × 111 mm W × 44.7 mm H. Black housing.
Important Notes
- The hardware arrives assembled and tested. Meshtastic configuration and network setup are up to you.
- For shipping safety the battery is disconnected from the RAK board. Reconnect it before use.
- The solar cable is permanently sealed into the enclosure. Sealing the cover plate is up to you. Dielectric grease works better than silicone because you can still open the housing later for maintenance.
- Meshtastic is open source and community supported, so I can't offer technical support for firmware or configuration.
- Not included: configuration, network setup or firmware support.
Frequently Asked Questions
Is this node ready to use?
The hardware is fully assembled and tested before it ships. You'll reconnect the battery and set up Meshtastic yourself.
Why is the battery disconnected?
It's disconnected from the RAK board for safe shipping. Just plug it back in before use.
Is the enclosure waterproof?
The solar cable entry is sealed. Final sealing of the cover plate is up to you.
Good to Know
Ships in 5–7 business days from Washington, Illinois. Printed housings can show small layer lines, and that's normal for 3D printed parts.